Cold Water Connection
Connect the cold water supply hose to a threaded 3/4(inch) connector and make sure
that it is fastened tightly in place.
If the water pipes are new or have not been used for an extended period of time, let the
water run to make sure that the water is clear. This precaution is needed to avoid the
risk of the water inlet to be blocked and damage the appliance.
Please close the hydrant after using.
WARNING!
Water Connection
Drain hose Connection
Insert the drain hose into a drain pipe with a minimum diameter of 40mm, or let it run into the sink, making sure to
avoid bending or crimping it. The top of the hose must be less than 1000mm.
M
A
X 1
0
0
0
m
m
A
Counter
Front
Drain pipe
NOTE
The top of the hose
must be less than
1000mm.
φ
40mm
B
PLEASE HANG UP THE DRAIN HOSE EITHER WAY OF A, B
18