15
Solutions to Common Dishwashing Problems
(continued)
Status Lights Flashing
• When first installed or when power has
been interrupted, HI-TEMP WASH and
HEAT DRY OFF status lights will flash. To
clear, press START/CANCEL pad. If power
failure occurs during a cycle, it will be
necessary to restart the dishwasher by
resetting the cycle you want.
Stains on Tub Interior
• Washing large amounts of dishware with
tomato based soil can cause a pink/orange
appearance. This will not affect performance
and will gradually fade over time. Pre-rinsing
will reduce the chance of staining. Using no
heat dry option will lessen staining.
To customize your dishwasher to match your cabinets:
•
You will need a trim kit.
•
See Step 10 of Installation Instructions that came with your dishwasher for more
information.
Removing Spots and Film
Hard water can cause lime deposit buildup on
the interior of the dishwasher. Dishes and
glasses may also get spots and film for a
number of reasons. (See Glassware/Flatware
Spotted or Cloudy section.) To remove buildup,
spots and film, clean using the following
instructions:
1. Load clean dishes and glasses in normal
manner. Do not load any metal utensils or
silverware.
2. Do not add detergent.
3. Select the POTS PANS cycle. Close and
latch door. Press START/CANCEL pad.
4. Allow dishwasher to run for 25 minutes to
reach the main wash portion of cycle.
5. Unlatch and open door and pour 2 cups of
white vinegar into the bottom of
dishwasher.
6. Close and latch door and allow cycle to
finish.
Note: If these conditions persist, a home
water softener should be considered.
