12
DOOR REMOVAL/REVERSAL
(UNITS WITH TEMPERATURE CONTROL OUTSIDE)
1. Lay the unit down on its back.
2. Disconnect the small blue and white
connectors located in the channel in
the bottom of the door (see Figure
1A).
3. Remove the gray cable from
underneath the 2 harness retaining
clips (see Figure 1B).
4. Pull the gray cable and connectors
through the hinge hole located on
the bottom of the cabinet using a
flat-head screwdriver.
5. Route the gray cable and the con-
nectors out from under the wheel
axle and the wheel spacer (see
Figure 2).
A
B
Figure 1
CAUTION
This procedure will require 2 people to
safely perform.
Figure 2
+
Figure 3
IMPORTANT
Before you begin, remove the electrical power cord from the wall outlet. Remove
any food from door shelves.
6. Slide the gray cable and connectors
out of the plastic channel located on
the bottom right side of the cabinet
(see Figure 3).
