Started
WITH YOUR
FRIGIDAIRE UPRIGHT 20 CU FT FREEZER
GETTING
Set your freezer temperature
It’s easy! When first turning your appliance on, adjust to
Recommended
. Some
models have a power indicator light projected on the floor. To ensure safe food
storage, allow the appliance to operate with the door closed for at least 8 hours
before loading it with food.
If necessary, we recommend you adjust the temperature
gradually, in small increments, allowing the temperature to stabilize.
YOU’RE IN CONTROL
1. Adjusting the appliance temperature control
to
OFF
turns off the compressor and prevents
the appliance from cooling but does not
disconnect the power to the light bulb and
other electrical components. To turn off
power to your appliance, you must unplug the
power cord from the wall outlet.
2. For warmer temperatures, adjust the setting
to
Cold
. For colder temperatures, adjust the
2
3
1
3
2
4
5
6
setting to
Coldest
.
3. The control can be left at the factory preset
(
Recommended
) or adjusted as desired.
4. If the temperature inside the cabinet increases, the red
High Temp*
light will
illuminate and the alarm will sound.
5. The
Freeze Boost*
mode quickly drives the appliance to a colder temperature
and stays active for up to 24 hours before automatically deactivating or being
manually exited.
6. Pressing the
Temp*
button will allow you to scroll through the five temperature
settings from
Cold
(top) to
Coldest
(bottom), and then loop back to
Cold
.
*Refer to your Use & Care Guide for detailed information.
BEFORE YOU START
Set up your freezer
Prior to using the freezer, make sure it is located on a floor that is level and strong
enough to support it fully loaded. Check out
INSTALLATION
in your Use & Care
Guide to see how to set the anti-tip bracket.
Before operating for the first time
Clean the inside of your appliance before using it. See the
CARE AND CLEANING
section in your Use & Care Guide.
A17275603 (1910)
