24
CLEANING AND CARE
Disconnect the power cord or leave the door open to deactivate the oven
during cleaning. Disconnect the power cord before replacing filters and lights.
Reconnect LED light to the harness and place the
.
LED light assembly back into the plastic housing.
4
Oven light replacement
Re-install LED light to the bracket with mounting screw.
3.
1. Remove the light cover by carefully pulling up on
Remove the LED bracket and light assembly. Remove
with part 5304499540.
To order parts call 800-599-7569.
6.
the front edge and pulling the cover forward.
the LED light from the bracket by removing the moun-
ting screw and replace only
5
Replace the microwave oven light cover by carefully
pushing into place (make sure the light cover rear tab is
Replace the charcoal filter (if installed).
Push the vent grill back into place (engaging both the
bottom and top tabs) and replace the vent grill mounting
screws.
Remove the vent grill (see steps 1-4 in charcoal filter
replacement section.
When re-installing mounting screw be careful not to
damage the LED light.
inserted into slot at rear).