Frigidaire FGBM19WNVDA, Installation Instructions Manual

Attach the microwave oven to the top cabinet.

Installation Instructions

3

MOUNT THE MICROWAVE
OVEN

B6.

FOR EASIER INSTALLATION AND PERSONAL
SAFETY, WE RECOMMEND THAT TWO PEOPLE
INSTALL THIS MICROWAVE OVEN. 

NOTE: 

If your cabinet is metal, use the nylon

grommet around the power cord hole to prevent
cutting of the cord.

NOTE:

We recommend using filler blocks if the 

cabinet front hangs below the cabinet bottom shelf.

IMPORTANT: If filler blocks are not 
used, case damage may occur from
overtightening screws.

Insert a self-aligning screw through top center 
cabinet hole. Temporarily secure the oven by 
turning the screw at least two full turns after the
threads have engaged. (It will be completely
tightened later.) Be sure to keep power cord
tight. Be careful not to pinch the cord, especially
when mounting flush to bottom of cabinet.

8

7

5

Cabinet Front

Cabinet Bottom Shelf

Tighten the outer two screws to the top of the
microwave oven. (While tightening screws, hold
the microwave oven in place against the wall and
the top cabinet.)

Filler Block

Microwave Oven Top

Equivalent 
to Depth 
of Cabinet
Recess

Insert 2 self-aligning screws
through outer top cabinet
holes. Turn two full turns on
each screw.

packed with the microwave.

Self-Aligning Screw

4

2

Rotate front of oven
up against cabinet 
bottom.

NOTE:

When mounting the

microwave oven, thread
power cord through hole in
bottom of top cabinet. Keep
it tight throughout Steps
1–3. Do not pinch cord or
lift oven by pulling cord.

Lift microwave, tilt it
forward, and hook
slots at back bottom
edge onto four lower
tabs of mounting
plate.

1

Tighten center
screw completely.

Install grease filters. See the Use &&&&and Care

IMPORTANT: Remove the cardhoard spacers between
heat shield and door.

IMPORTANT: Do not grip or use the handle

or heat shield during installation. Do not 
remove the cardboard spacers between the 

heat shield and door.

6

EN-19