7
For most cooking
, start on the highest control setting and then turn to a lower
one to complete the process. Use the chart below as a guide for determining
proper flame size for various types of cooking. The size and type of utensil used
and the amount of food being cooked will influence the setting needed for
cooking.
For deep fat frying
,
use a thermometer and adjust the surface control knob
accordingly. If the fat is too cool, the food will absorb the fat and be greasy.
If the fat is too hot, the food will brown so quickly that the center will be
undercooked. Do not attempt to deep fat fry too much food at once as the food
will neither brown nor cook properly.
*Flame Size
Type of Cooking
High Flame
Start most foods; bring water to a boil; pan broiling
Medium Flame
Maintain a slow boil; thicken sauces, gravies; steam
Low Flame
Keep foods cooking; poach; stew
*These settings are based on using medium-weight aluminum pans with
lids. Settings may vary when using other types of pans.
Never extend the flame beyond the
outer edge of the utensil. A higher
flame simply wastes heat and energy,
and increases your risk of being burned
by the flame.
Proper Burner
Adjustments
Setting Surface
Controls
Flame Size
The surface control knob shown below
may not look identical to the surface
control knobs on your range; it is only
representational.
The color of the flame is the key to proper burner adjustment. A good flame
is clear, blue and hardly visible in a well-lighted room. Each cone of flame
should be steady and sharply defined. Adjust or clean burner if flame is yellow-
orange. To clean burner, see instructions under
General Cleaning
.
Your range is equipped with 4 standard burners, 2 standard and 2 large
burners, or 3 standard and 1 large burner. Regardless of size, always select a
utensil that is suitable for the amount and type of food being prepared. Select
a burner and flame size appropriate to the pan. Never allow flames to extend
beyond the outer edge of the pan.
For models equipped with the large burners, the larger burner is best used
when bringing large quantities of liquid to temperature and when preparing
larger quantities of food.
Each burner lights automatically from an electric ignitor each time a control
knob is turned to the
LITE
position.
To operate the surface burner:
1.
Place cooking utensil on burner.
2.
Push
the Surface Control knob
in
and
turn counterclockwise
out of the
OFF
position.
3.
Release the knob and rotate to the
LITE
position.
Note:
All four electronic
ignitors will click at the same time. However, only the burner you are turning
on will ignite.
3.
Visually check that the burner has lit.
4.
Push
the control knob
in and turn
counterclockwise
to the desired flame
size. The control knobs do not have to be set at a particular mark. Use the
guides and adjust the flame as needed.
DO NOT
cook with the Surface Control
knob in the
LITE
position. (The electronic ignitor will continue to click if left in
the
LITE
position.)
In the event of an electrical power outage, the surface burners can be lit
manually. To light a surface burner, hold a lit match to the burner head, then
slowly turn the Surface Control knob to
LITE
. Use caution when lighting
surface burners manually.
Do not place plastic items such as salt and pepper shakers,
spoon holders or plastic wrappings on top of the range when it is in use.
These items could melt or ignite. Potholders, towels or wood spoons could
catch fire if placed too close to a flame.
