18
To Remove and Replace Oven Door
To Remove Oven Door
1. Open the door.
2. Remove screws located on the inside of the oven door near the hinges (one
on each side).
3. Close the door to the quarter-open position. Grasp the door firmly on both
sides and lift up and off the hinges.
4. To clean oven door, follow the instructions provided in the cleaning chart
under
General Cleaning
.
To Replace Oven Door
1. Be sure the hinge arms are in the quarter-open position. Be careful if pulling
the hinges open by hand. The hinges may snap back against the oven frame
and could pinch fingers.
2. Hold the door at the sides near the top. Insert the hinge arms into slots at
the bottom of the door.
3. Hinge arms must go into the range slots evenly. The hinge arms should be
inserted into the bottom corners of the door as far as they can go.
4. If the door is not in line with the oven frame, remove it and repeat the above
steps.
5. Replace screws previously removed.
To Remove and Replace Warmer Drawer (some models)
To Remove Warmer Drawer:
1.
Turn power off before removing the warmer drawer.
2. Open the drawer to the fully opened position.
3. Locate the latches on both sides of the warmer drawer. The left latch is
visible. However, the right side is not and is located inside the drawer glides.
4. Pull up on the left glide latch while inserting a screwdriver over the right latch
and pushing down.
5. Pull the drawer away from the range.
6. To clean warmer drawer, see "Porcelain Enamel" in the cleaning chart on
page 16.
To Replace Warmer Drawer:
1. Align the glide latches on both sides of the drawer with the slots on the
drawer.
2. Push the drawer back into the range.
Electrical Shock Hazard
can occur and result in serious injury or
death. Disconnect appliance from electric power before cleaning and servicing
the warmer drawer.
General Cleaning
(continued)
The door is heavy. For
safe, temporary storage, lay the door
flat with the inside of the door facing
down.
Summary of Contents for FGF367CGSB
Page 23: ...23 ...
