Frigidaire FHWC3025, Installation, Use & Care

14

Replace screw in the filter  

  retainer.

To clean grease filter, soak  

  the filters in hot water using 

  a mild detergent. Rinse well  

  and shake to dry. Or place  

  in upper rack of dishwasher  

  to clean.  

NOTE:

 Do not use ammo-

nia. The aluminum on the grease filter will corrode and 

darken. 

NOTE:

 You can use either dishwasher or hot detergent 

solution and rinse in clean water. 

NOTE

The grease filter is dishwasher safe.   

To avoid grease filter damage while cleaning, 

place filter into the dishwasher top rack for 

cleaning

Replacing the Incandescent LightBulb

Turn off the range hood and allow the light bulb to cool.

Disconnect power - Turn off house breaker at breaker box.

Squeeze the plastic lens cover and remove it from the hood.

Screw a 

75W max, 120V 

  incandescent light bulb  

  into socket.

Replace lens cover by  

  squeezing cover and  

  inserting tabs into  

  slots. 

Reconnect power. 

If new light does not operate, make sure the lamp is  

inserted correctly before calling service. 

Charcoal / Grease Filter Accesory Kit

For recirculating vent hood, an optional charcoal filter is 

available. You can order this as part number 5304486302.  

The charcoal filter is not washable. It should last up to 6 

months with normal use.

Replace the old charcoal filter with a new charcoal filter.

4.

.

1.

.

.

4.

.

.

A

A. Filter screw

RANGE HOOD CARE

A

B

A. Light bulb socket

B. Lens cover

Cleaning

WARNING

To Reduce The Risk Of Fire Or Electrical shock 

disconnect from power supply before cleaning.

IMPORTANT

Clean the hood and grease filters frequently 

according to the following instructions. Replace 

grease filter before operating hood.

IMPORTANT

Exterior Surfaces

Do not use soap-filled scouring pads, abrasive cleaners, 

Cooktop Polishing Creme, steel wool, gritty washcloths 

or paper towels.

To avoid damage to the stainless steel, do not use 

cleaners that contain chlorine.

Cleaning Method:

Use warm water with liquid detergent or all purpose 

  cleaner and soft cloth to clean outside surfaces. 

Rinse with clean water and dry with soft, lint-free cloth.

Use glass cleaner to remove fingerprints.

For stainless steel finish rub in direction of grain to  

  avoid scratching or damaging the surface. 

NOTE: 

On stainless steel finish, clean in direction of 

stainless steel brush to avoid scratching or damaging    

the surface. 

To clean or replace grease filter:

Remove screw from the plastic filter retainer clip with   

  phillips screwdriver 

Turn the filter retainer to release filter.

Reinstall the filter by placing the back edge in the

  channel at rear of hood. Push filter into place, turn

  the filter retainer to secure filter to range hood.

•

•
•
•

1.

.

.

A

A. Filter screw