Frigidaire FJWC369TEIS, Instruction Manual

The range hood must be connected 
with copper wire only.

The range hood should be connected 
directly to the fused disconnect (or 
circuit breaker) box through metal 
electrical conduit.

Wire sizes must conform to the 
requirements of the local codes and 
ordinances.

Before installing the hood

1. For the most efficient air flow 

exhaust, use a straight run or as 
few elbows as possible. Vent unit to 
outside of building, only.

2. At least two people are necessary 

for installation.

3. The hood is fitted with screws and 

drywall anchors suitable for most 
surfaces, consult a qualified 
installer, check if they perfectly fit 
with your cabinet/wall.

4. Do not use flex ducting.

5. Cold weather installations should 

have an additional backdraft 
damper installed to minimize 
backward cold air flow and a 
nonmetallic thermal break to 
minimize conduction of outside 
temperatures as part of the 
ductwork. The damper should be 
on the cold air side of the thermal 
break.
The break should be as close as 
possible to where the ducting 
enters the heated portion of the 
house.

6. Make up air: local building codes 

may require the use of make-up air 
systems when using ducted 
ventilation systems greater than 
specified CFM of air movement.
The specified CFM varies from 
locale to locale.

Important

Ventilation duct should have exit 
towards outside of the building.

Description

28

27

E

N

G

E

N

G

Control panel
Lamps
Grease filter handle
Grease filter

1

2

Glass
Duct covers
Louver holes

5

6

3

7

4

1

2

5

6

7

3

4