Adjustment to different types
of gas
Let only an authorized person do the
adjustment to different types of gas.
If the appliance is set for liquid gas you
can change it to natural gas, with the
correct injectors.
The gas rate is adjusted to suit.
WARNING!
Before you replace the injectors, make
sure that the gas knobs are in the Off
position. Disconnect the appliance
from the electrical supply. Let the
appliance cool down. There is a risk of
injury.
The appliance is set to default gas. To
change the setting always use the
gasket sealing.
A
B
C
D
E
A. Gas connection point (only one point is
applicable for the appliance)
B. Gasket
C. Adjustable connection
D. Natural Gas pipe holder
E. LPG pipe holder
Hob injectors replacement
Replace the injectors when you change the
gas type.
1. Remove the pan supports.
2. Remove the caps and crowns of the
burner.
3. Remove the injectors with a socket
spanner 7.
4. Replace injectors with the ones
necessary for the type of gas you use.
5. Replace the rating plate (it is near the
gas supply pipe) with the one for the
new type of gas supply.
You can find this plate in the bag
supplied with the appliance.
If the supply gas pressure is not constant or
it is different from the necessary pressure,
install an applicable pressure adjuster on
the gas supply pipe.
Adjusting the minimum gas
level on the hob burner
1. Disconnect the appliance from the
electricity.
2. Remove the knob for the hob. If there is
no access to the bypass screw
31
INSTALLATION
Summary of Contents for FNGZ60JNPS
Page 36: ...867306177 C 432015 ...