•
Never remove or damage stickers, warning labels or
nameplates attached to the appliance.
•
A qualified technician carrying out the installation is obliged
to observe applicable national standards and regulations
concerning connection to the water distribution system and
the electric network. The manufacturer is not responsible for
any unprofessional or incorrect installation.
•
Check that the specifications written on the appliance’s
identification plate are the same as those of the electrical
power supply.
•
This appliance is manufactured and tested in accordance
with valid regulations.
Special information
The power cable may only be replaced (for example if
damaged) by a qualified contractor authorised by the
manufacturer, using an original spare part.
Do not install the water dispenser in a location where there is a
direct impact of sunlight or near heat sources, as a stove,
oven, etc
Put the appliance on a flat surface and keep a minimum
distance of 25 cm from the wall & make sure that the
ventilation openings of the product are not being obstructed.
Never clean your Appliance with flammable fluids such as
alcohol, kerosene, gasoline, paint thinner, solvents, chemicals
or abrasives as detergents, acids, vinegar or products that
might leave the smell.
Clean your Appliance as described in "CARE AND
CLEANING" chapter.
3
SAFETY INFORMATION
