The machine had been disinfected before
departed from the factory.
Never clean your water cooler with
flammable fluids such as alcohol, kerosene,
gasoline, paint thinner, solvents, chemicals
or abrasives as detergents, acids, vinegar
or products that might leave the smell.
Wipe the outside of the water dispenser
with water and neutral detergent.
Do not use chemical cleaners or volatile
solvents, because the product can lose
brightness and colour.
Wipe with a soft, clean piece of cloth in part
outside of water dispenser regularly.
The water inside the bottle must not contain
chlorine additive. so it’s very important that
the inside of the water dispenser is
sterilized and clean.
Do not touch the water outlet to avoid its
contamination. The water reservoir must be
cleaned and sterilized every 3 months.
Water will fall from the water collector if it is
completely filled with water. Empty the
water collector periodically.
Procedure for cleaning &
sterilization of the appliance
1. Disconnect the appliance from power
source.
2. Remove the water bottle and empty
water reservoir through pressing the
buttons until there is no water coming
out.
3. Open the drainage cap, existing at the
back of the dispenser, and ensure that
all the water flow out of the appliance.
4. Prepare a chlorinated solution (2 litres
of clean water and 0.5 tea spoon of
bleach).
5. Place the chlorinated solution in an
empty bottle of water and fill your water
dispenser.
6. Wait 10 minutes for the chlorinated
solution take effect and remove all the
water through the two buttons (run out
all the water).
7. Fill 1/3 of the bottle with clean water.
Replace the bottle and remove all the
water by triggers and drainage cap.
This will rinse the tanks and the triggers
of your product.
WARNING!
Always disconnect the water dispenser
from power source before cleaning it
or doing any maintenance.
WARNING!
If you need to move the water
dispenser to a new place inside or
outside your house, you must empty
all the water through the drain cap.
8
CARE AND CLEANING
