26
SETTING OVEN CONTROLS
Operating the oven light
The interior oven light will automatically turn ON when the
oven door is opened.
Press
to turn the interior oven light ON and OFF
whenever the oven door is closed.
The interior oven light is located at the upper left rear wall
of the oven interior and is covered with a glass shield held
by a wire holder. The glass shield must be in place
whenever the oven is in use.
Your appliance has been factory calibrated and tested to
ensure an accurate baking temperature. For the first few
uses, follow your recipe times and temperature
recommendations carefully. If you think the oven is
cooking too hot or too cool for your recipe times, you can
adjust the control so the oven cooks hotter or cooler than
the temperature displayed.
The oven temperature my be inc35°F (+19°C) or
decreased -35°F (-19°C) from the factory settings.
Example: increase the oven temperature by 30°F:
Adjusting the oven temperature
Step
Press
1. Press and
hold bake
for 6 seconds.
2. Enter 30.
3. To accept, press
start
.
Example: decrease the oven temperature by 30°F:
Step
Press
1. Press and
hold bake
for 6 seconds.
2. Enter 30.
3. Press
self clean
.
4. To accept, press
start
.
NOTES
Restoring to factory default settings
When new, your appliance was set with a few
predetermined oven control settings. Over time, the user
may make changes to these default settings.
The following functions or features have user program
options or adjustments that may have been changed from
the original default settings:
• 12 or 24 hour clock
display mode.
•
6-Hour Engergy Savings
or
continuous bake
mode.
•
Silent
or
audible
keypad operation.
•
Oven
temperature display
mode (F° or C°).
•
Any oven
temperature offset
adjustment made.
•
Temp probe
options (some models).
•
Any s
tored favorite recipes
(some models).
Before restoring the settings, please be aware that
all
changes
made to the oven control settings will be
erased once the start keypad is pressed. This includes
any temperature offset made for the oven when baking.
IMPORTANT
1. Press
and hold 7
keypad until
acceptance tone sounds
(about 6 seconds).
2. To accept, press
start
.
Step
Press
To restore oven control to default settings:
•
Oven temperature adjustments made will not affect
the broil or self-cleaning feature temperatures.
•
If the temperature shows an adjustment of -30°F, and
a +30°F adjustment is needed, you can toggle
between the (-) or (+) in the display by pressing
self
clean
.
•
DO NOT USE oven thermometers such as those found
in grocery stores to check the temperature settings
inside your oven. These oven thermometers may vary
as much as 20 to 40 degrees from actual
temperatures.
NOTE
The oven light will not operate during a self-clean
cycle. If the oven light is on when setting self-clean,
the oven light will turn off.