31
Step
Press
1. The oven should be empty and
all
oven racks
removed. Remove
all items from the cooktop. Be sure
the oven door is
completely
closed.
2. Press
delay start.
3. Enter
9 0 0.
4. Press
start.
5. Press
self clean
once for a 3-hour
clean time, press self clean twice for
4-hour clean and press 3 times
for a 2-hour self-clean cycle time.
6. Press
start
to accept.
Example: To program a self-cleaning cycle with a
delay start time of 9:00 o’clock:
Setting a delay start self-clean cycle
1. Press
keypad.
2. If the self-clean cycle has heated the oven to a high
temperature, the "
Hot
" (Fig. 1) message will show in
the display. Allow enough time for the oven to cool
and for the "
door OPn
" message to display (Fig. 2).
When this message turns off the oven door may be
opened.
If it becomes necessary to cancel self-clean:
Restarting a self-clean cycle after a power outage:
If a self-clean cycle was cancelled
using the cancel
keypad
before the oven was finished cleaning, you may
wish to set for another self-clean cycle.
If self-clean was cancelled shortly after being started, and
the oven interior did not reach high self-clean
temperatures, the next clean cycle may be set as soon as
the oven door unlocks from the cancelled clean cycle.
If the oven became hot enough from the cancelled self-
clean cycle, you may be required to wait up to 4 hours
before the control will allow another self-clean cycle to
start.
NOTES
•
The maximum
delay start
setting is 11 hours & 59
minutes.
•
Check to be sure the oven is
empty
before setting a
self-clean cycle using a
delay start
time. Immediately
after setting self-clean with a
delay start
the oven
door will lock. The self-clean feature will not start
heating the oven for cleaning until reaching the delay
start time.
If a self-clean cycle was interrupted by a power failure,
your oven may not have thoroughly cleaned. If so, once
power is restored, the oven has cooled and the oven door
has unlocked, if needed, set again for self-clean.
Fig. 1
Fig. 2
Press
cancel
at any time to stop self-clean.
SELF-CLEANING
Starting another self-clean after cancellation:
NOTE
If attempting to set "back to back" self-clean cycles,
the control may display the messages "
CLEAn
" , then
"
dELAy
" followed by the length of time to wait before
the next self-clean may be set. For example, if the
message displayed reads "
4:00
", the control will not
allow for another self-clean cycle within the next 4
hours.
