Select the temperature setting most suitable for
each load. The REGULAR--HIGH HEAT, PERM
PRESS--MEDIUM HEAT, KNITS--MEDIUM-LOW
HEAT*(some models) and DELICATES--LOW
HEAT temperature settings may be used with any
cycle setting.
Cycle Selection
Turn cycle selector clockwise to desired cycle and
setting.
The Automatic Dry and Timed Dry cycles end with
a cool down period. The heat automatically turns
off and the load continues to tumble during the cool
down period. This reduces wrinkling and makes
items easier to handle during unloading.
Drying time varies depending on size and
dampness of load, weight and fabric type. Room
temperature and humidity, type of installation and
electrical voltage or gas pressure can also affect
drying time.
OPERATING INSTRUCTIONS
Before Operating Your Dryer
Read your dryer Use and Care Guide. It has
important safety and warranty information. It also
has many suggestions for best drying results.
To reduce the risk of fire, electric
shock, or injury to persons, read the IMPORTANT
SAFETY INSTRUCTIONS in your dryer Use and
Care Guide before operating this appliance.
Operating Steps
Read Drying Procedures in your Use and Care
Guide. It explains these operating steps in detail.
1. Prepare items for drying.
2. Check that lint screen is clean and in place.
3. Load the dryer. If desired, add a dryer fabric
softener sheet.
4. Close the dryer door.
5. Set Temperature and Cycle Signal controls.
6. Turn cycle selector clockwise to desired
setting.
7. Start dryer. Turn the Turn to Start control
clockwise to ON. Hold for 1-2 seconds and
release.
8. When Cycle Signal control is on, a signal
will sound at the end of the cycle.
9. Remove items immediately and hang or fold.
10. Clean lint screen after every load.
Temperature Selection
Always follow directions on fabric care
labels.
To avoid fire hazard, do not use
heat to dry items containing feathers or down, foam
rubber, plastics, or similarly textured, rubber-like
materials. Use the Air Fluff-No Heat cycle only.
Printed in U.S.A.
P/N 134065900 (0106)
*
some models
*
