9
Replacing the Light Bulb
•
This fireplace consists of 4 bulbs (E-12, 40W) that illuminate a flame effect. The light
bulbs need to be replaced if you notice a dark section of the flame or when the flames
lose clarity.
•
Warning
- Always disconnect from the power outlet before removing bulbs to reduce the
risk of fire, electric shock or damage to property.
•
Warning
- The bulb reaches high temperatures during operation. Allow it to cool down
before replacing it.
•
This process requires 2 people.
•
Un-mount the fireplace and carefully lay it flat on the floor.
•
Access the bulb by removing the four screws located on the back panel.
•
Replace the bulb with a new one. Extra caution should be taken because the bulb can
be hot.
•
Close the panel lid using screws.
•
Warning
– Do not use fireplace without properly putting the lid back in place.
•
For assembly, reverse this process.
Troubleshooting
Problem
Possible Solution
Unit does not work / does not heat
!
Check if the unit is plugged in the power
outlet.
!
Check if the unit is in Standby mode. If so,
turn the unit ON.
!
Check if the heat is turned OFF.
!
Check for safety cut-off operation.
No flame effect
!
Check if the unit is plugged in the power
outlet.
!
Check if the unit is in Standby mode. Turn
the unit ON.