ENG
7
4.2 Adjusting the shelf (not applicable to units with plastic inner liner)
To adjust the shelf first unload it, lift it and unclip the shelf clips (4). Place the clips in the desired
position and reposition the shelf. Make sure that the horizontal metal rods at the bottom of the shelf
are between the front and back shelf clips.
4.3 Connection to the mains supply
Connect the ICM to a 220-240 Volts power supply on a min 10A fused & grounded socket. Do not use
extension cables.
Do not connect the merchandiser to:
a non grounded wall socket or power line
improper supply voltage and frequency
power supply that does not comply with the safety regulations of
the appliance or with current legislation on electrical installations
Do not plug the cooler into a multiple outlet strip or use
extension cables.
If the supply cord is damaged, it must be replaced by the
manufacturer or authorized service provider.
Route the power cables in such a way that they are protected
from damage and they do not pose a risk of tripping.
4.4 Operation instructions
The thermostat is located inside the ICM. The thermostat is factory set to approx. +4.1 °C. If you
require a higher temperature (warmer), turn the thermostat knob anticlockwise. If you require a lower
temperature (colder), turn the thermostat knob clockwise.
Do not use electrical appliances inside the storage compartments of the
appliance, unless recommended by the manufacturer.
