TROUBLESHOOTING
Any trouble occurring might be due to a minor problem that you can correct yourself following
the instructions below. Do not try any further action if the pointers given cannot solve the
problem!
Repairs on the cabinet must be made only by a qualified refrigeration engineer. Incompetent
repair work can cause serious personal danger: contact your service organisation for any
repairs needed.
Cabinet does not work (no audible running noise or only fan noise audible
Possible Cause:
a)
automatic evaporator defrosting active or
thermostat switched off
b)
power plug not connected
c)
fuse blown, power plug or socket defective
d)
condenser fins dirty
Corrective Measure:
None: cooling will automatically
switch on again
Insert plug properly. Switch ON
Contact your electrician or service
organisation
Contact service organisation for
maintenance
Storage Temperatuere too high
a) automatic defrosting active
None: Temporary minor temperature
rise during defrosting is normal
b) ambient temperature too high or
Avoid extreme operating
`
environment i.e temperature over 25
°
Adjust storage temperature-controller
c) distance to wall not adhered
Maintain presribed minimum distance
c) lack of air intake due to
Remove any obstacles in air intake
obstruction of grill
area
d) condenser fins dirty
Contact engineer to perform
maintenance
Storage Temperature too low
a) misadjustment
Adjust storage temperature in small
increments
Cabinet lighting failed
a) lighting not switched on
Switch lighting on
b) the starter or light fitting is defective
R
eplace starter or complete fitting
Heavy Condensation in Display Area
Extreme ambient temperature – relative humidity
Improve operating environment.
is more than 60% or very high summer temps
install air onditioning to reduce
room temperature to below 25
°
C
Water under or in front of cabinet
a) automatic defrosting defective
Wipe water off. If new water forms
b)extreme operating environment. Relative
within the next 48 hours contact your
humidity over 60% or high summer temperatures
service organisation
causes overflow of drip tray
Formation of Odour in Cabinet
a)
Spaces under return air grill dirty
Clean
b)
Drain pipe blocked
Remove blockage
c)
Spillage
Clean
In the interest of continual product development we reserve the right to change any of the
details and specifications without notice.
Page 16
