Supply voltage and frequency must be in acccordance with the data shown on the cabinet type
plate. The local utility company’s regulations on earth-fault protection must be observed. If in
doubt, consult a qualified electrician.
The cabinet must not be plugged into a multiple outlet power strip
Run the power cables so that they are protected from risk of damage and there is no risk of
tripping
STARTING and COMMISSIONING
If the cabinet has been sharply tilted while being sited or for counting of accessories, it must be
left to stand for at least three hours before being started to allow the lubricating oil to settle in
the compressor. Failure to do so can cause total destruction of the refrigeration system
Ensure the means of transporting/positioning used does not damage elements which exist in the
lower part of the equipment.
Start the cabinet only if it has been installed as described and where the room temperature is not
over 25
°
C
-
plug power plug into socket
-
switch on
Starting is signalled by the running noise of fans and refrigeration system
In the interest of continual product development we reserve the right to change any of the
details and specifications without notice.
Page 5
