MAINTENANCE
Maintenance must be carried out by a qualified refrigeration engineer every three months.
The positioning and type of defective elements to be repaired or replaced can be seen in the
spare parts drawings
In order to prevent accidents: WHERE THE MANIPULATION AND/OR REPLACEMENT
OF ELECTRICAL COMPONENTS IS TO BE CARRIED OUT, ALWAYS DISCONNECT
THE UNITS FROM THE ELECTRIC MAINS BEFOREHAND
Turn off power supply to the cabinet by disconnecting the power plug before starting any
maintenance on the cabinet
In the case of breakdown in the functioning of the unit, the user must carry out the necessary
steps to prevent the deterioration of the product. i.e. destocking and removal of the product to an
operational storage facility.
Where operational faults are detected, check the electrical protection and switches to make sure
they are in perfect condition. If the fault persists, advise the maintenance contractor.
Cleaning the condenser fins
The refrigerated cabinet must be maintained by a qualified refrigeration engineer every three
months: and in addition, the condenser fins need cleaning by a qualified refrigeration engineer
whenever a layer of dust or fluff begins to build up between the fins
-
disconnect the power plug
-
unscrew 4 recessed head screws with a screw-driver
-
remove front grill
-
check whether the condenser fins need cleaning
-
clean fins with vacuum cleaner and brush attachment
-
replace front grill after cleaning
-
put cabinet in operation
Regular cleaning of the condensers is important to save power and to avoid unnecessary
breakdown
In the interest of continual product development we reserve the right to change any of the
details and specifications without notice.
Page 9
