|
3
User Instructions Low Temperature Freezers Model GLE
Livøvej 22 - 8800 Viborg - Tlf. 86 61 34 11 - www.frigor.dk
User Instructions Low Temperature Freezers Model UNI/LT
6. Electrical supply.
The electrical supply should always be in
accordance with the rating plate on the
back of the freezer.
The supply must always be in accordance
with the law and regulations regarding
electrical safety, if any doubts contact your
supplier.
7. Starting Up.
In case the compressor does not start when
the freezer has been plugged in, the electri-
cal supply may not be in order. Check if
there is an electricity supply to the plug or if
the fuse is blown. If not please go to trouble
shooting page 6. 18.
8.Operating the freezer
The empty freezer should be switched on
for at least 5-6 hours prior to loading of the
freezer. The freezer should not be loaded
above the inside walls which is also the load
line limit.
Please note: After the lid has been opened,
there will be a vacuum created inside the
freezer due to the low temperatures. Wait a
few minutes before trying to reopen the lid
otherwise the handle could be damaged.
9.Defrosting.
In order for the freezer to work to its maxi-
mum efficiency the cabinet should be de-
frosted when a approx. 2mm thick ice layer
has formed inside the cabinet.
The ice layer is easily removed with a plastic
or wooden scraper.
Never use a sharp metal
object which might will cause damage to
the inner liner.
The defrosting frequency is determined
mainly by two factors the usage pattern
(number of lid openings) and the relative
humidity. Excess water can be drained out
by using the drain water outlet on the front
of the freezer.
10.Cleaning.
Cleaning should be done when needed.
When used in a dirty environment it might
be necessary to remove the compressor
compartment grill, and clean the compres-
sor compartment eventually with a vacuum
cleaner.
If the cleaning process is neglected there
is a risk that the performance of the freezer
will be effected, and even damage to the
compressor could occur due to overheat-
ing.
11. Storage.
If the freezer is stored for a period of time,
the lid should be kept open for free circula-
tion of air inside the cabinet in order to
avoid corrosion of the inner liner.
12. Temperature control
GLE
- freezers.
The temperature inside the freezer is con-
trolled by the electronic controller in the
front grill. The controller has a digital readout
of the temperature inside the cabinet. and
3
Fig. 1
