19
USING CART STOPS
(IF EQQUIPPED)
HOOK
PUSH TO
CLOSE
LATCH
4.
When loading the platform
at bed level, make sure cart
stops are open
(FIG. 23-1)
.
Push load out of the vehicle
to correct position on the
platform. Place all loads as
close as possible to the in-
board edge of the platform
with heaviest part toward
the vehicle body as shown
in
FIG. 23-1
. If standing
on platform with the load,
stand in the footprint area
shown and comply with the
WARNING
on page 18.
Pulling the load from vehicle to platform can result in a fall from
platform and serious injury. When unloading vehicle, always
push the load out on the platform.
WARNING
!
CART STOPS CLOSED
FIG. 23-2
5.
Unload platform with cart stop
at ground level as shown in
FIG. 23-2
. Make sure cart
stop is closed before mov-
ing load off the platform. To
close, push the cart stop and
hook in place
(FIG. 23-3)
.
CLOSING CART STOPS
(RH SIDE OF FLIPOVER)
FIG. 23-3
6.
Move load off the platform
as shown in
FIG. 23-2
.
NOTE:
Cart stops are kept
closed with a hook
(FIG. 23-3)
. Make sure
latch is locked.
LOADING PLATFORM AT BED LEVEL
(DUAL CART STOPS OPEN)
FIG. 23-1
INBOARD
EDGE
VEHICLE
BODY
PLATFORM
CART STOPS
CART STOPS
