1-800-672-4399
Available exclusively at
STEP 2
Lift the front of the top section
as shown, and put the steel door in place
by setting the bottom two rods into the
holes on the bottom section (a). Insert
the top two rods into the holes on the
top section (b).
STEP 5
When you close each door, make
sure it’s completely shut in place before
releasing the pins, and then check to make
sure the door is secure.
STEP 3
Make sure the top and bottom
sections are aligned and locate the holes
along the rim. Insert bolts from the
underside of the rim through the holes
and secure the bolts by screwing them
into the wing nuts on the top side (see
image). Tighten wing nuts by hand only,
and check them before each use to make
sure they are fully tightened and secure.
STEP 1
Separate the top section from
the bottom section and loosely place
the top half on the bottom half.
STEP 4
To open the front door,
squeeze the two pins together and
then pull on the door while keeping the
pins together. The top door is similar;
squeeze the two pins together and pull
up while keeping the pins together.
KENNEL ASSEMBLY INSTRUCTIONS
Assembly instructions for kennel models 122090 (Pink 19-inch), 122124 (Blue 19-inch), 122091
(Pink 24-inch), and 122125 (Blue 24-inch).
Plastic Top Section
Plastic Bottom Section
Top Door With Handle
1
3
PARTS INCLUDED
5
9 Bolts
9 Wing Nuts
Steel Door
4
2
(a)
(b)
You will need only 9 bolts
and 9 wing nuts for assembly,
but each assembly packet
contains additional parts.
wing nut
bolt
wing nut
bolt
