Technical data
ACT VS 3000 - 6000
EN - 37
11.16 Electronic drainer
This drain consists of a condensate accumulator where a capacitive sensor checks the liquid level continuously: as soon
as the accumulator is filled, the sensor passes a signal to the electronic control and a diaphragm solenoid valve will
open to discharge the condensate. For a complete condensate discharge the valve opening time will be adjusted exactly
for each single drain operation. No condensate strainers are installed. No adjusting is required. A service valve is
installed before the electronic drain in order to make check and maintenance easily.
At dryer start-up verify that this
valve is open.
Control panel
Power / Service Led
(green)
ON - ready to work / supplied
Blinking
– maintenance required
Alarm Led (red)
Blinking
– alarm condition
Power+Alarm Led
ON - circuit board defect
TEST Button
Discharge test (keep pushed for 2 seconds)
Troubleshooting
Only qualified personnel should perform troubleshooting and or
maintenance operations.
Prior to performing any maintenance or service, be sure that :
•
no part of the machine is powered and that it cannot be connected to the mains
supply.
•
no part of the machine is under pressure and that it cannot be connected to the
compressed air system.
•
maintenance personnel have read and understand the safety and operation
instructions in this manual.
PLEASE REFER TO INSTRUCTION MANUAL OF ELECTRONIC DRAINER
