19
TEMP(+2s)
Press and hold 2s will force console to search sensor
manually
WIND -
Press to switch between average wind speed and, wind
gust.
Press and hold for two seconds to switch the wind
direction to display in degrees or in letters.
RAIN/PRE
Press and hold for two seconds switch between Rain and
Pressure.
While in Rain mode, press to switch between Rain Rate,
Rain Events, Hourly Rain, Daily Rain, Weekly Rain,
Monthly Rain and Yearly Rain
While in Pressure mode, press to switch between Relative
pressure and Absolute pressure
LIGHT
LIGHT(+2S)
Press to adjust the LCD backlight brightness (high, medium
and off); only available when powered by USB connection
Press to exit the SET mode at any time.
Wake up WiFi listening when battery powered only
TEMP+
(and)
RAIN PRE
Press this two buttons at the same time for 4 seconds to
activate BLE function for Wi-Fi configuration (refer to
section 8.1.2)
[MODE] +
[LIGHT] + 5s
Press Mode and Light button for 5s to make factory
default reset.
Table 7: Key function
6.3 Setting mode
Note:
DST, Time Zone setting can only be programmed via WS View APP.
You will need to set time zone info properly if you have the console connected
to internet and these setting need to be adjusted for your setup, otherwise
console will be synchronized to default setting if you don’t setup these
parameters on the APP properly.
Press and hold the
MODE
button for two seconds to enter the Set Mode. To
proceed to the next setting, press (do not hold) the
MODE
button.
To exit the SET mode at any time, press the
LIGHT
button.
summarizes the set mode sequence and commands.
Summary of Contents for WH3900
Page 44: ...44 List display Weather Map...
