57
environments, inspect the batteries every 3 months (while
cleaning the solar panel).
5.
When replacing the batteries, apply a corrosion preventing
compound on the battery terminals, available at Amazon and
most hardware stores.
6.
In snowy environments, spray the top of the weather station with
anti-icing silicon spray to prevent snow build up.
12. Troubleshooting Guide
Problem
Solution
Outdoor sensor array
does not
communicate to the
display console.
The sensor array may have initiated properly and the data
is registered by the console as invalid, and the console
must be reset. Press the reset button as described in
Section 5.2.
With an open ended paperclip, press the reset button for 3
seconds to re-sync the console with the sensor array about
10 feet away.
The LED next to the battery compartment will flash every
16 seconds. If the LED is not flashing every 16
seconds…
Replace the batteries in the outside sensor array.
If the batteries were recently replaced, check the polarity.
If the sensor is flashing every 16 seconds, proceed to the
next step.
There may be a temporary loss of communication due to
reception loss related to interference or other location
factors, or the batteries may have been changed in the
sensor array and the console has not been reset. The
solution may be as simple as
powering down and up the
console
(remove AC power and batteries, wait 10 seconds,
and reinsert AC power and batteries).
Summary of Contents for WH3900
Page 44: ...44 List display Weather Map...
