7
10. Battery door
11. Reset button
1.1. Install U-bolts and metal plate
Installation of the U-bolts, which are in turn used to mount the sensor
package on a pole, requires installation of an included metal plate to
receive the U-bolt ends. The metal plate, visible in Figure on the
right side, has four holes through which the ends of the two U-Bolts
will fit. The plate itself is inserted in a groove on the bottom of the
unit (opposite side of solar panel). Note that one side of the plate has
a straight edge (which goes into the groove), the other side is bent at
a 90-degree angle and has a curved profile (which will end up
“hugging” the mounting pole). Once the metal plate is inserted,
remove nuts from the U-Bolts and insert both U-bolts through the
respective holes of the metal plate as shown in Figure
Figure 1: U-Bolt installation
Loosely screw on the nuts on the ends of the U-bolts. You will tighten
these later during final mounting. Final assembly is shown in Figure
2.
