32
Note
Beside the antenna, there is an arrow icon with ”NORTH” words (Figure
9)representing the direction of north. The sensor body has to be
adjusted so that the “NORTH” indication is facing to real north direction
in your location. A compass device is recommended to help adjust
direction. Permanent wind direction error will be introduced when the
outdoor sensor is not installed in right direction.
Figure 9
Now look at the bubble level. The bubble should be fully inside the
red circle. If it is not, wind direction, speed, and rain readings may
not operate correctly or accurately. Adjust the mounting pipe as
necessary. If the bubble is close, but not quite inside the circle, and
you cannot adjust the mounting pipe, you may have to experiment
with small wooden or heavy cardboard shims between the sensor
package and the top of the mounting pole to achieve the desired
result (this will require loosening the bolts and some
experimentation).
Make sure you check, and correct if necessary, the northly
orientation as the final installation step, and now tighten the bolts
with a wrench.
6. Reset Button and Transmitter LED
Using a bent-open paperclip, press and hold the RESET BUTTON
(see Figure 10) to affect a reset: the LED turns on while the
RESET button is depressed, and you can now let go. The LED
should then resume as normal, flashing approximately once every
48 seconds.
