FFM-TITAN-1500-PRO USER MANUAL
< 4 >
•
CAUTION: When transferring product from extreme temperature environments, (e.g. cold truck to warm humid ballroom) condensation
may form on the internal electronics of the product. To avoid causing a failure, allow product to fully acclimate to the surrounding
environment before connecting it to power.
•
Do not mount the product on a flammable surface (linoleum, carpet, wood, paper, carton, plastic, etc.).
•
Do not use in a confined space. Always install the product in a location with adequate ventilation, at least 20 in (50 cm) from adjacent
surfaces.
•
When hanging this product, always secure to a fastening device using a safety cable.
•
Be sure that no ventilation slots on the product’s housing are blocked or clogged by dust. If necessary, remove the dust.
1.5.3
Power and Wiring
•
Always make sure that the voltage of the outlet to which you are connecting the product is within the range stated on the decal or rear
panel of the product.
•
Make sure the power cord is not crimped or damaged.
•
Never connect this product to a dimmer pack or rheostat.
•
Never disconnect the product from power cord by pulling or tugging on the cord.
•
To eliminate unnecessary wear and improve its lifespan, during periods of non-use completely disconnect the product from power via
breaker or by unplugging it
1.5.4
Operation
•
Do not operate this product if you see damage to the housing or cables. Have the damaged parts replaced by an authorized technician
at once.
•
Do not use the product as a space heater.
•
Make sure there are no flammable materials close to this product while it is operating.
•
The maximum ambient temperature (Ta) is 104 °F (40 °C). Do not operate the product at higher temperatures.
•
Do not cover the ventilation slots when operating to avoid internal overheating.
•
Do not cover or plug the output nozzle during operation.
•
Wipe up spitted fluid immediately. Moisture – also fluid – can destroy the electric.
•
You may hear a loud popping sound during operation. This is normal.
•
Never carry the product by the power cord or any moving part. Always use the handles of the machine.
•
Drain the tank before transporting the product.
•
Always disconnect the product from the power source before cleaning.
•
In the event of a serious operating problem, stop using the product immediately.
•
This product contains no user-serviceable parts. Any reference to servicing in this user manual will only apply to properly trained, certified
technicians. Do not open the housing or attempt any repairs which can lead to damage or malfunction.
Keep this User Manual for future use. If you sell the product, be sure that the purchaser receives this document.
2
INTRODUCTION
2.1
Description
The Titan 1500 PRO features an Over-sized Heater Core to increase run times, Quick Ready Fog Technology (QRFT) has you ready to fog in
less than 10 seconds after full cycle and it is ready to fog, and Advanced Low Fluid Sensing shuts down the machine when you run out of
fluid to protect the heater core. The 1500 PRO also boasts a whopping 1600W heater core to produce over 30,000 CFM. Instant Stop
Technology (IST) pulls fluid out of core to reduce spitting and give precise fog output.
