18
General
Equipment con
-
cept
The cooling unit FK 2200 is suitable for the following power sources:
-
TransTig 2200
-
MagicWave 1700/2200
Overview
The cooling unit perfectly fits in the modular
product concept of the power sources
TransTig 2200 and MagicWave 1700/2200.
The cooling unit is combined with the power
source to form a unit. As in the case of the
power source, the combination of power
source and cooling unit is also suitable for
being mounted on the carriage.
The cooling unit FK 2200 can also be equipped with the optional “flow controller“ and the
“temperature limit controller“. If the cooling unit is fitted with these options or if you have a
FK 2200 FC variant with a flow sensor, the power source will always switch off for process
reliability reasons if one of the following events occur:
-
The flowrate drops below a determined flowrate value (e.g. the coolant level in the
coolant container is too low)
-
A determined water return temperature is exceeded (e.g. welding torch overheated)
A corresponding alarm message is displayed on the operating panel of the power source.
Area of applica
-
tion
The cooling unit FK 2200 can be used for:
-
MagicWave 1700
-
TransTig / MagicWave 2200
-
Water-cooled manual TIG torch, also for TIG cold-wire welding
-
Water-cooled machine TIG torch, also for TIG cold-wire welding
The maximum cable assembly lengths for the welding torches are as follows:
-
18 m (59 ft.) in the case of MagicWave 1700
-
18 m (59 ft.) in the case of TransTig / MagicWave 2200
Information about
the coolant
CAUTION!
Danger from using non-permitted coolant.
This can result in serious damage to property.
► Only use coolant available from the manufacturer.
► Do not mix different coolants.
► When changing the coolant, make sure all the coolant is replaced.
► When switching from ethanol-based coolant to FCL 10 coolant, Change Kit FCL10
must be used and the instructions provided must be followed.
