23
EN
Connecting the cooling unit to the power source
Connect power
source with cool
-
ing unit
Plug-type connection between power source and co
-
oling unit
Switch mains switch in position “O“
Place power source on cooling unit:
Leave the power source suspended
from a suitable lifting device over the
cooling unit
Pull connection plug (8) of the power
source as far as possible through the
opening at the bottom
Connect plug-type connection (9) between power source and cooling unit
CAUTION!
Kinked or damaged cables can cause short circuits.
When positioning the power source, prevent the connection plug and the cable from getting
kinked or damaged.
Carefully place the power source on the cooling unit
Mounting angles for mounting the power source
Fix power source with enclosed screws
(10) at front and rear side of the cooling
unit
CAUTION!
Danger caused by overturning or falling
devices.
Check all screwed connections for tight
seat.
Transport of cool
-
ing unit and pow
-
er source
CAUTION!
There is danger of injury due to dropping devices.
For the transport of the power source with the cooling mounted fixed it is required that the
power source is equipped with a “transport handle“.
(8)
(9)
1
2
3
4
5
(10)
6
