47
EN
Safety rules
General
Environmental
conditions
Electrical installa-
tions
The device is manufactured using state-of-the-art technology and according
to recognised safety standards. If used incorrectly or misused, however, it can
cause:
-
injury or death to the operator or a third party,
-
damage to the device and other material assets belonging to the operat-
ing company,
-
inefficient operation of the device.
All persons involved in commissioning, maintaining and servicing the device
must
-
be suitably qualified,
-
have knowledge of and experience in dealing with electrical installations
and
-
read and follow these operating instructions carefully.
The operating instructions must always be at hand wherever the device is be-
ing used. In addition to the operating instructions, attention must also be paid
to any generally applicable and local regulations regarding accident preven-
tion and environmental protection.
All safety and danger notices on the device
-
must be in a legible state,
-
must not be damaged,
-
must not be removed,
-
must not be covered, pasted or painted over.
Only operate the device when all protection devices are fully functional. If the
protection devices are not fully functional, there is a risk of
-
injury or death to the operator or a third party,
-
damage to the device and other material assets belonging to the operator,
-
inefficient operation of the device.
Any safety devices that are not functioning properly must be repaired by a suit-
ably qualified engineer before the device is switched on.
Never bypass or disable protection devices.
For the location of the safety and danger notices on the device, refer to the
section headed "General remarks" in the operating instructions for the device.
Before switching on the device, remove any faults that could compromise
safety.
This is for your personal safety!
Operation or storage of the device outside the stipulated area will be deemed
as "not in accordance with the intended purpose". The manufacturer shall not
be held liable for any damage arising from such usage.
For exact information on permitted environmental conditions, please refer to
the "Technical data" in the operating instructions.
Electrical installations must only be set up set up to the relevant national and
local standards and regulations.
