22
Notes on Anti-theft device
Anti-Theft Device
An optional anti-theft device is included in the scope of delivery.
If required, the anti-theft device is installed before the inverter is screwed to the wall brack-
et.
To ensure that the fixing screws cannot fall out in the inverter's data communications area,
these are fitted with a screw release.
To remove the fixing screw from the inverter
-
Push the fixing screw upwards from the other side e.g. using needle-nose pliers
-
Undo the fixing screw
Installing the Anti-Theft Device
IMPORTANT!
Please refer to the instructions for attaching the inverter to the wall bracket.
Swing the inverter out
Push the fixing screw upwards from
the other side e.g. using needle-nose
pliers
Undo the fixing screw
Insert the fixing screw into the anti-theft
device
Insert the anti-theft device plus fixing
screw into the inverter
Swing the inverter in
Tighten both fixing screws to the speci-
fied torque
2
2
1
TX25
1
2
3
2
22.13 lb-in
1.84 ft. lb.
2.5 Nm
3
1
TX25
4
5
6
7
Summary of Contents for Galvo 208-240 1.5-1
Page 2: ...2...
Page 4: ...4...
Page 23: ...23 EN US Fit the padlock to the anti theft device 2 2 1 max 0 28 in 7 mm 8...
Page 31: ...31 EN US...
