1
EN-US
IMPORTANT SAFETY INSTRUCTIONS - SAVE THE-
SE INSTRUCTIONS
General
These operating instructions contain important instructions for the inverter that must be fol-
lowed during installation and maintenance of the inverter.
The inverter is designed and tested according to international safety requirements, but as
with all electrical and electronic equipment, certain precautions must be observed when in-
stalling and/or operating the inverter.
To reduce the risk of personal injury and to ensure the safe installation and operation of
the inverter, you must carefully read and follow all instructions and safety instructions in
these operating instructions.
Failure to follow these instructions and other relevant safety procedures may result in voi-
ding of the warranty and/or damage to the inverter or other property!
General
These operating instructions contain important instructions for the inverter that must be fol-
lowed during installation and maintenance of the inverter.
The inverter is designed and tested according to international safety requirements, but as
with all electrical and electronic equipment, certain precautions must be observed when in-
stalling and/or operating the inverter.
To reduce the risk of personal injury and to ensure the safe installation and operation of
the inverter, you must carefully read and follow all instructions and safety instructions in
these operating instructions.
Failure to follow these instructions and other relevant safety procedures may result in voi-
ding of the warranty and/or damage to the inverter or other property!
Safety
The following section "Safety“ contains various warnings. A Warning describes a hazard
to equipment or personnel. It calls attention to a procedure or practice, which, if not correc-
tly performed or adhered to, could result in damage to or destruction of part or all of the
Fronius inverter and/or other equipment connected to the Fronius inverter or personal in-
jury.
Electrical installa-
tions
All electrical installations must be carried out in accordance with the National Electrical
Code, ANSI/NFPA 70, and any other codes and regulations applicable to the installation
site.
For installations in Canada, the installations must be done in accordance with applicable
Canadian standards.
Summary of Contents for Primo 208
