Fronius TransCut 300, Operating Instructions/Spare Parts List

9

EN

Devices with the CE marking satisfy the essential requirements of the low-
voltage and electromagnetic compatibility directive (e.g. relevant product
norms from the EN 60 974 series).

Safety

The operator is obliged to arrange a safety inspection of the device at least
once every 12 months.

The manufacturer recommends that the power source is calibrated during
the same 12 month period.

A safety inspection must be carried out by a qualified electrician
- after any changes are made
- after any additional parts are installed and after any conversions
- after repair, care and maintenance
- at least every twelve months.

For safety inspections, follow the appropriate national and international
standards and directives.

Further details on safety inspection and calibration can be obtained from your
service centre. They will provide you on request with any documents you may
require.

Safety inspection

Copyright of these operating instructions remains with the manufacturer.

Text and illustrations were accurate at the time of printing. We reserve the
right to make amendments. The contents of the operating instructions shall
not provide the basis for any claims whatever on the part of the purchaser.
We are grateful for any suggestions for improvement and for drawing our
attention to any errors in these instructions.

Copyright

Do not dispose of this device with normal domestic waste!
To comply with the European Directive 2002/96/EC on Waste Electrical and
Electronic Equipment and its implementation as national law, electrical
equipment that has reached the end of its life must be collected separately
and returned to an approved recycling facility Any device that you no longer
require must be returned to our agent, or find out about the approved collec-
tion and recycling facilities in your area.
Ignoring this European Directive may have potentially adverse affects on the
environment and your health!

Disposal

Class B devices comply with EMC requirements for industrial areas and
residential areas with a direct power supply from the public low-voltage grid.

Class A devices are not designed for use in residential areas with a direct
power supply from the public low-voltage grid. When Class A devices are
used in such areas, problems may arise in terms of guaranteeing electroma-
gnetic compatibility and with regard to both line-bound and radiated interfe-
rence.

EMC device
classes in accor-
dance with EN/
IEC 60974-10