Fronius TransCut 300, Operating Instructions/Spare Parts List

2

The device is to be used exclusively for its intended purpose.

The device is designed exclusively for plasma cutting.
Utilisation for any other purpose, or in any other manner, shall be deemed to
be „not in accordance with the intended purpose“. The manufacturer shall
not be liable for any damage resulting from such improper use.

Utilisation in accordance with the „intended purpose“ also comprises
-

reading all operating instructions carefully and following them thoroughly

-

studying and obeying all safety and danger notices carefully

- performing all stipulated inspection and servicing work.

The device is designed for use in industry and the workshop. The manufac-
turer accepts no responsibility for any damage caused through use in living
quarters.

The manufacturer likewise accepts no liability for inadequate or incorrect
results.

Utilisation in
accordance with
„intended purpo-
se“

Before switching on the device, remove any faults that could compromise
safety.

Your personal safety is at stake!

General remarks

(continued)

Operation and/or storage of the device outside the stipulated area will be
deemed as „not in accordance with the intended purpose.“ The manufacturer
shall not be liable for any damage resulting from such improper use.

Surrounding temperature:
-

during operation: -10 °C to + 40 °C (14 °F to 104 °F)

-

for transport and storage: - 25 °C to + 55 °C (-13 °F to 131 °F)

Relative humidity:
-

up to 50 % at 40 °C (104 °F)

-

up to 90 % at 20 °C (  68 °F)

Keep ambient air free from dust, acids, corrosive gases and substances, etc.

For use at altitudes above sea level: up to 2000 m (6500 ft)

Environmental
conditions

The operator undertakes to allow only such people to work with the device
who:
-

are familiar with the fundamental instructions regarding safety and
accident prevention, and have been instructed how to use the device

-

have read and understood the „Safety rules“ section and warning notices
in these operating instructions, and then signed them to confirm this

-

are trained to produce the required results.

Checks must be carried out at regular intervals to ensure that operators are
working in a safety-conscious manner.

Obligations of
the operator