37
EN
Start-up
General informa-
tion
The wire-feed unit is commissioned by pressing the torch trigger (for manual applications)
or by means of a welding start-up signal (for automatic applications).
Requirements
When commissioning the wire-feed unit, the following requirements must be met:
-
Wire-feed unit connected to the power source using the interconnecting hosepack
-
Welding torch connected to the wire-feed unit
-
Feed rollers inserted into the wire-feed unit
-
Wirespool or basket-type spool and adapter inserted in the wire-feed unit
-
Wire electrode fed in
-
Feed roller contact pressure set
-
Brake adjusted
-
All covers closed, all side panels in place, all protection devices intact and in their
proper place
WARNING!
Operating the equipment incorrectly can cause serious injury and
damage. Do not use the functions described until you have thoroughly read and
understood the following documents:
-
these operating instructions
-
all the operating instructions for the system components, especially the safe-
ty rules
