18
General
Device concept
VR 4000/VR 4000-30 wire-feed unit
VR 4000-30 TIME wire-feed unit
The wire-feed units are designed to be used with wirespools of max. 300 mm (11.81 in)
diameter. The standard 4-roller drive has good wirefeeding properties. The wirefeeders are
also suitable for long hosepacks. Due to their compact size, the wirefeeders can be used
in many different ways.
The VR 4000-30 TIME wire-feed unit is specially designed for the TIME high-performance
welding process. All the important TIME process functions can be set directly on the wire-
feed unit control panel using the integrated 3-parameter control. The following functions
are not available:
-
MIG/MAG standard manual welding
-
Job mode
-
LocalNet connection (e.g. operation with remote control or JobMaster welding torch)
REQUIREMENTS
To operate the wirefeeder, it must first be configured for use with the corresponding power
source:
Application area
-
VR 4000: for all types of MIG/MAG welding
-
VR 4000-30: primarily used with TS/TPS 7200 and TS/TPS 9000 high-performance
power sources. In conjunction with the TR 2100 remote control, and also with the
TIME 5000 Digital power source
-
VR 4000-30 TIME: in conjunction with the TIME 5000 Digital high-performance power
source, for all types of MIG/MAG high-performance welding
VR 4000
VR 4000-30
VR 4000-30 TIME
TransSynergic 4000/5000
X
X
-
TransSynergic 7200/9000
X
X
-
TransPuls Synergic 3200/4000/5000
X
X
-
TransPuls Synergic 7200/9000
X
X
-
TIME 5000 Digital
-
X
X
TransPuls Synergic 2700 Duo
X
-
-
TransPuls Synergic 2700 Duo TIG
X
-
-
