51
EN
Adjusting the shoe
If it is no longer possible to adjust the shoe to the extent described below, change the shoe
(see “Changing the shoe”).
Undo the hexagonal nut (51)
Detach the shoe (50), complete with the sensor (49), from the carrier arm (48)
Unscrew the shoe from the sensor in such a way that the gap between the slide-face
of the shoe and the surface of the sensor is 2 mm
–
When unscrewing the sensor, take care that the cable does not get twisted.
Insert the shoe (50), complete with the sensor, into the carrier arm
Tighten the hexagon nut (51)
Changing the shoe
Undo the hexagon nut (51)
Detach the shoe (50), complete with the sensor (49), from the carrier arm (48)
Unscrew the shoe (50) from the sensor (49)
–
When unscrewing the sensor, take care that the cable does not get twisted.
Screw the new shoe onto the sensor:
–
in such a way that the gap between the slide-face of the shoe (50) and the surface
of the sensor (49) is 2 mm
Tighten the hexagon nut (51)
Dispsal of used
parts and materi
-
als
Dispose of used parts and waste materials in line with the principle of waste separation.
-
Wherever possible, return all re-usable materials for recycling (steel and other ferrous
metals, aluminium, brass, plastics)
-
Dispose of brake linings and friction linings in the “residual refuse” collection
-
Dispose of the oil filling of the damper in compliance with local or national waste-dis
-
posal laws
1
2
3
4
5
1
2
3
4
5
Summary of Contents for VR 4040
Page 2: ...2...
Page 4: ...4...
Page 34: ...34 More details on mounting the end of wire watchdog 2 mm...
Page 55: ...55 EN...
