33
EN
No.
Function
(1)
"Parameter selection" button (right)
a) for selecting the following welding parameters
Arc length correction
for correcting the arc length
Welding voltage in V
*)
Before the start of welding, the device automatically displays a standard value
based on the programmed parameters. During welding, the actual value is
displayed.
Arc-force dynamic
for influencing the short-circuiting dynamic at the moment of droplet transfer
- ... harder, more stable arc
0 ... neutral arc
+ ... soft, low-spatter arc
Real Energy Input
for displaying the energy applied during the welding operation.
**)
b) for changing parameters in the Setup menu
(2)
"Parameter selection" button (left)
a) for selecting the following welding parameters
Sheet thickness
Sheet thickness in mm or in.
Welding current
*)
Welding current in A
Before the start of welding, the device automatically displays a standard value
based on the programmed parameters. During welding, the actual value is
displayed.
Wire feed speed
*)
Wire feed speed in m/min or ipm.
b) for changing parameters in the Setup menu
(3)
Adjusting dial (right)
for changing the arc length correction, welding voltage and arc-force dynamic pa-
rameters
for changing welding parameters in the Setup menu
(4)
Adjusting dial (left)
for changing the sheet thickness, welding current and wire feed speed parameters
for selecting welding parameters in the Setup menu
(5)
"Process" button
***)
for selecting the welding process
MANUAL - MIG/MAG standard manual welding
SYNERGIC - MIG/MAG standard synergic welding
STICK - manual metal arc welding
Summary of Contents for VR 5000 noSpool
