84
The "Ignition time-out" function (ito) is explained in the "Special functions and options" sec-
tion.
SPt
Spot time - spot / stitch welding time
Unit: s
Setting range: OFF, 0.1 - 5
Factory setting: OFF
SPb
Spot break - stitch pause time
Unit: s
Setting range: OFF, 0.1 - 10 (in 0.1 s increments)
Factory setting: OFF
FAC
Factory - Reset power source to factory setting
Press and hold down the "Dynamic" (manual control panel) or "Parameter selec-
tion" (Synergic A control panel) button for 2 seconds to restore the factory settings.
When "PrG" is shown on the digital display, the power source has been reset.
IMPORTANT!
When the power source is reset, all the personal settings in the Set-
up menu are lost. When the power source is reset, operating points that were
saved using the "Save" buttons are not deleted, but are retained in the memory.
The functions in the second level of the Setup menu (2nd) are also not deleted. Ex-
ception: Ignition time-out function parameter (ito).
2nd
Second level of the Setup menu (see "Setup menu - level 2")
Setup parameters
for MMA welding
IMPORTANT!
If you reset the power source using the FAC factory setup parameter, the
hot-current time (Hti) and HotStart current (HCU) setup parameters are also reset.
HCU
HotStart current
Unit: %
Setting range: 100 - 200
Factory setting: 150
Hti
Hot-current time
Unit: s
Setting range: 0 - 2.0
Factory setting: 0.5
Ast
Anti-Stick
Unit: -
Setting range: On, Off
Factory setting: Off
FAC
Factory - Reset power source to factory setting
Press and hold down the "Dynamic" (manual control panel) or "Parameter selec-
tion" (Synergic A control panel) button for 2 seconds to restore the factory settings.
When "PrG" is shown on the digital display, the power source has been reset.
IMPORTANT!
When the power source is reset, all personal settings are lost.
When the power source is reset, operating points that were saved using the "Save"
buttons are not deleted, but are retained in the memory. The functions in the sec-
ond level of the Setup menu (2nd) are also not deleted. Exception: Ignition time-
out function parameter (ito).
2nd
Second level of the Setup menu (see "Setup menu - level 2")
Summary of Contents for VR 5000 noSpool
