89
EN
Parameters for
manual metal arc
(MMA) welding in
the Setup menu
level 2
PFS
Permanent Feeder Speed - wire feed speed is permanently displayed
Unit: mm (in.)
Setting range: ON / OFF
Factory setting: OFF
If the setting is "ON", the wire feed speed (m/min) is permanently displayed on
the manual control panel instead of the welding current (A). In this case the hold
value for the welding current (A) is deactivated.
ALC
Arc Length Correction - correction of the arc length via the welding voltage
Setting range: ON / OFF
Factory setting: OFF
The arc length depends on the welding voltage. The welding voltage can be ad-
justed to suit individual needs in Synergic operation.
If the ALC parameter is set to "OFF", the welding voltage cannot be adjusted.
The welding voltage is automatically determined by the selected welding current
or wire speed. If the arc length correction is adjusted, the voltage changes, but
the welding current and wire speed remain the same. When setting the arc length
correction using the adjusting dial, the left display is used for the correction value
of the arc length. The welding voltage value on the right display changes simul-
taneously. Afterwards the left display shows the original value, e.g. welding cur-
rent.
r
r (resistance) - welding circuit resistance (in mOhm)
see "Measuring welding circuit resistance r"
L
L (inductivity) - welding circuit inductivity (in microhenry)
see "Displaying welding circuit inductivity L"
Summary of Contents for VR 5000 noSpool
