46030 / 10 ft. Nordman Fir Pro Shape Tree
Page 2
each of the three screws into the holes on the stand’s middle section, being sure that
screws do not extend so far as to interfere with installation of the tree pole. Place tree
stand in desired location.
Fig. 2A
2.2 –
Locate
Tree Section “A”
and remove the protective caps that are on the top and
bottom of the pole (they can be replaced when you re-pack your tree). Insert Tree Section
“A” into the tree stand (See Fig. 2B)
.
Make sure the pole is firmly inserted into the stand,
and then turn all three screws until contact is made with the pole. If Section “A” is not
sitting straight, then simply loosen the screws, adjust tree pole, and retighten the screws.
Fig. 2B
All the branches are connected to the tree’s center pole by metal
hinges (See Figure 2). Remove the packing strap that is around the
tree section and allow the branches to fall into place.
As this is a
FRONTGATE Pro Shape Tree, the leaves will spring into
their correct position so NO SHAPING IS NECESSARY!!!
2.3
– Locate
Tree Section “B”
and insert into the top of Tree Section “A”. Make sure
section “B” is seated securely into the top of section “A” (See Fig. 2C). Remove the
packing strap that is wrapped around this tree section, same as you for Section “A”. Allow
the branches and leaves to fall into place.
Fig. 2C