61248 / 10 ft. Royal Spruce Pro Shape Tree
Page 2
screws into the holes on the stand’s middle section, being sure that screws do not extend so far
as to interfere with installation of the tree pole. Place tree stand in desired location.
Fig. 2A
2.2
- Locate
Tree Section “A”
and remove the protective caps that are on the top and bottom
of the pole (they can be replaced when you re-pack your tree). Insert Tree Section “A” into the
tree stand (See Fig. 2B)
.
Make sure the pole is firmly inserted into the stand, and then turn all
three screws until contact is made with the pole. If Section “A” is not sitting straight, then
simply loosen the screws, adjust tree pole, and retighten the screws.
Fig. 2B
All the branches are connected to the tree’s center pole by metal hinges
(See Figure 2). Remove the packing strap that is around the tree section
and allow the branches to fall into place.
As this is a FRONTGATE
Pro Shape Tree, the leaves will spring into their correct position,
ONLY MINIMAL SHAPING IS NECESSARY!!!