IMPORTANT: BEFORE LIGHTING THE GRILL:
Inspect the gas supply hose prior to turning the
gas ON. If there is evidence of cuts, wear, or
abrasion, the hose must be replaced prior to use.
Do not use the grill if the odor of gas is present.
Only the pressure regulator and hose assembly
supplied with the unit should be used.
Never substitute regulators for those supplied with
the grill. If a replacement is necessary, contact
Frontgate or a certified grill technician for proper
replacement.
IMPORTANT: ALWAYS OPEN THE LID
BEFORE ATTEMPTING TO LIGHT THE GRILL.
Lighting the Grill with Electronic Ignition
Push and turn one of the main burner knobs to HI
position (see illustration, page 12). As you push
down you will hear the igniter click. You will know
the grill has lit when you hear a whoosh sound
(and you will see a blue flame) when the flame
ignites after a few clicks.
Adjust to the heat level desired after the burner is
lit.
Lighting the Rotisserie with Electronic Ignition
Push and turn the knob labeled Rotisserie to the
HI position (see illustration, page 12). As you push
down you will hear the igniter click. You will know
the grill has lit when you will see a blue fame
spread across the rear burner when the flame
ignites after a few clicks.
Adjust to the heat level desired after the burner is
lit.
Flame Characteristics
Each burner is adjusted prior to shipment;
however, variations in the local gas supply may
make minor adjustments necessary. The flames
of the burners should be visually checked for
proper burner fame characteristics. Burner flames
should be blue and stable, no excessive noise or
lifting.
If the flame is yellow, it indicates insufficient air. If
the flame is noisy and tends to lift away from the
burner, it indicates too much air. If any of these
conditions exist, call for assistance.
GRILL LIGHTING INSTRUCTIONS
Flame Height
approximately 1 inch
11
