6.
INSERT THE MIDDLE (“SECTION B”) INTO THE LOWER (“SECTION A”) TREE POLE. FINISH BY
INSERTING THE TOP (“SECTION C”) INTO THE MIDDLE (“SECTION B”) TREE POLE. . (FIG 3~4)
FIGURE 3 FIGURE 4
7.
LOCATE THE PLUG FROM SECTION C AND PLUG INTO THE RECEPTACLE HUB LOCATED IN
SECTION B. THE HUB WILL HAVE A YELLOW CARD ATTACHED FOR EASY IDENTIFICATION.
8.
ALLOW THE HINGED BRANCHES TO FALL INTO PLACE OR GENTLY PULL UP AND OUT EACH
BRANCH.
9.
SHAPE THE BRANCHES, STARTING AT THE BOTTOM WITH THE TIPS FARTHEST FROM THE POLE
AND CURVING OUT FROM THE POLE. ONE TO THE RIGHT, ONE TO THE LEFT AND ONE AT THE
CENTER. TO ACHIEVE A REALISTIC LOOK, EACH BRANCH SHOULD BE SHAPED.
10.
SHIFT ANY BRANCHES AS NECESSARY TO FILL ANY GAPS AND SLIGHTLY UPSWEEP ALL
BRANCHES FOR A UNIFORM LOOK.
11.
LOCATE AND PLUG THE TWO EXTENSION CORDS FROM SECTIONS A & B INTO THE SELECTED
OUTLET OR INTO THE DOUBLE OUTLET REMOTE RECEIVER. PLUG LOCATER MARKERS ARE
COLOR CODED ON EACH SECTION. THIS WILL ALLOW EASIER PLUG IN LOCATION FOR FUTURE
ASSEMBLY.
(SECTION A EXT. CORD) (SECTION B EXT. CORD) (SECTION C CORD)
