46040 / 10 ft. Nordman Fir Pro Shape FlipTree
Page
3
As your Flip Tree is turning, the branches will fall into place as all the tree branches are on
hinges.
Your FRONTGATE tree is also made with a PRO SHAPE
CONSTRUCTION which means all of the leaves will spring into place...
Only Minimal shaping is required with your newly purchased PRO
SHAPE FLIPTREE!
Your FlipTree comes with a Fliplock system. Once the tree is totally upright, you will want to
lock the tree into place using our factory installed attached lock in band (See Fig 3D). Wrap the
band around the bottom of the tree and also around the Flip Tree Support bar. Push in the two
prong lock clip into the female plastic housing (See Fig 3E). It will lock with a Click. To take
off the lock, push on both sides of the clip, and it will release (this step should be done only
when the tree is being readied for storage).
Fig 3A Fig 3B Fig 3C Fig 3D Fig 3E
4.
Tree Top Assembly:
Now that you tree is upright and locked into place, next step is place the tree tops on. The
Tree Top is in two pieces, Section “B” and Section “C”.
Place Section “B” into the top of Tree Section “A” (See Fig. 3F and 3G). Next, put Section
“C” into the top of Section “B” (See Fig. 3H).
Fig. 3F Fig. 3G Fig. 3H
