ASSEMBLY
OM 0437SB1388-A
16
Installation of the 5RDF0071 Hydraulic Deflector for 2 part Chute
(Figures 9-9a)
3. Figure 9:
Remove a circlip (items 1-4)
from each cylinder pin (items 2-3) and
remove the pins. Placing the hydraulic
ports in the position shown on figure,
attach the fixed end of the cylinder
(item 6) to the chute base (item 5) and
the rod end to the deflector with the pins
and circlips.
4. Figure 9:
Install the male ends of the two
elbow flow restrictors on the cylinder
ports, pointing up the outputs and at the
angles shown in figure.
5. Figure 9a:
Install a 1/2"NPT quick
coupler with a dust cap (items 6-7) at one
end of the two hoses.
6. Figure 9a:
Attach the other end of the
hoses (item 2) to the cylinder elbows
(items 1).
7. Figure 9:
Install the hose support
(item 7) using two 5/16"NC x 1" serrated
flange bolts and 5/16"NC serrated flange
nuts (items 8-9).
8. Figure 9:
Attach the hose clamp
(item 11) with a 3/8"NC x 1 1/2" bolt and
3/8"NC nut (items 10 & 12). Do not
tighten.
9. Figure 9a:
Attach hoses (item 2) to the
hose support previously installed by
running them inside the hose clamp.
10. Figure 9a:
Attach hoses (item 2) to the
hose support located on the three point
hitch with the hose clamp (item 4), a
3/8"NC x 1 1/2" bolt and 3/8"NC nut
(items 3 & 5).
11. Figure 9a:
Secure with 1/4" x 15" lg
nylon tie wraps to the illustrated locations
(items 8).
NOTE:
Make sure to leave enough play to
the hoses to allow full rotation of the chute
and that the radius of curvature of the
hoses remains correct. Also make sure
they do not cross and they do not rub
against sharp edges. Rotate the chute
and move the deflector to ensure that
hoses are well assembled.
Figure 9a
Figure 9
Summary of Contents for SB1388
