18. EFFECTS LEVEL/MIX - Sets return level for effects loop in Series Mode. Determines effects blend in
Parallel Mode.
19. PRESENCE - Active, all three channels
20. DEPTH - Variable damping.
NOTE:
When switching to half power mode (standby switch in Position I) impedance selector value can be
divided by two to compensate for the impedance mismatch caused by Half Power Mode.
EXAMPLE
: Impedance setting “8” for 16 ohm speaker, Impedance setting “4” for 8 ohm speaker, etc. While
not necessary, it may help extend tube life and maintain low-end punch. Experiment with it both ways.
TUBE FUNCTION AND LOCATION CHART
Preamp tube locations are indicated by tube type on the rear panel of the chassis. Tube types are factory
selected for superior performance, consistent tone quality and reliability. While substituting other brands may
not cause damage to the amplifier this may affect amplifier performance in unpredictable ways. For best
performance, replace only with factory recommended tubes.
Warning!
Substituting other tube types is not
recommended.
Each 12AX7 has two sections/functions. Section A is shown first, Section B is second. Factory recommended
tubes are listed under each location. Numbering sequence is right to left looking at back of amp starting with
the row closest to front panel of amp.
V1 (shielded tube)
Input Gain Stage 1 and signal splitter for both channels
12AX7WB Sovtek
Gain Stage 2 for Green channel
12AX7 China Selected Use in place of WB if more gain is required.
V2
Gain Stage 2 for Red channel
12AX7 China
Gain Stage 4 for Red and Green channels. Active when Gain Switch is set to HI.
V3
Gain Stage 3 for Red and Green channels
12AX7 China
Tone Control Driver for Red and Green channels.
V4
Phase
Inverter
12AX7 China
V5-6
Power
Tubes
EL34 Mullard (Russia)
EL34B-STR
EL34 Svetlana (Russia)
EL34EH (Russia)
V7
Rectifier
Tube
5U4GB Russia
